- Home
- Networking
- CCNP Troubleshooting 642-832
91.
You want to tunnel IPv6 traffic across an IPv4 portion of a network. In interface configuration mode for the tunnel you are configuring, what IP address would you enter after the tunnel source command
- A.The IPv6 address assigned to the local tunnel interface
- B.The IPv4 address assigned to the local interface on which the tunnel is built
- C.The IPv6 address assigned to the remote tunnel interface
- D.The IPv4 address assigned to the remote interface on which the tunnel is built
- Answer
- Report
Answer : [B]
92.
Identify two OSPFv3 characteristics that are not characteristics of OSPFv2. (Choose
the two best answers.)
- A.Uses a hierarchical structure divided into areas
- B.Requires direct connectivity from the backbone area to all other areas
- C.Uses link-local addresses to identify neighbors
- D.Allows communication between two nodes connected to a common link, even though the two nodes might not share a common subnet
- Answer
- Report
Answer : [C, D]
93.
In what configuration mode is the following OSPFv3 command issued?
ipv6 ospf process-id area area-id
ipv6 ospf process-id area area-id
- A.Router configuration mode
- B.Route-map configuration mode
- C.Global configuration mode
- D.Interface configuration mode
- Answer
- Report
Answer : [D]
94.
What command lists the state of a router's adjacency with all configured OSPFv3
neighbors? (Choose the best answer.)
- A.show ipv6 ospf
- B.show ipv6 ospf neighbor
- C.show ipv6 ospf interface
- D.debug ipv6 ospf adj
- Answer
- Report
Answer : [B]
95.
RIPng sends routing updates to what multicast address?
- A.224.0.0.9
- B.FF02::9
- C.FE80::
- D.224.0.0.5
- Answer
- Report
Answer : [B]
|
|
||||||||||||||||||||||||||||
