Home
116.
A CAPWAP tunnel terminates on which one of the following controller interfaces?
  • A.
    Virtual interface
  • B.
    Dynamic interface
  • C.
    Service port interface
  • D.
    AP-manager interface
  • Answer & Explanation
  • Report
Answer : [D]
Explanation :
CAPWAP tunnels always terminate on the AP-manager interface. All the APs discover the controller by that interface and its IP address. The management interface can terminate CAPWAP tunnels if no AP-manager interface exists.
Report
Name Email  
117.
Which one of the following is used to relay DHCP requests from wireless clients?
  • A.
    Management interface
  • B.
    Dynamic interface
  • C.
    Virtual interface
  • D.
    Service port interface
  • Answer & Explanation
  • Report
Answer : [C]
Explanation :
The virtual interface is used to relay DHCP requests from wireless clients.
Report
Name Email  
118.
Which one of the following controller interfaces maps a WLAN to a VLAN?
  • A.
    Bridge interface
  • B.
    Virtual interface
  • C.
    WLAN interface
  • D.
    Dynamic interface
  • Answer & Explanation
  • Report
Answer : [D]
Explanation :
A dynamic interface makes a logical connection between a WLAN and a VLAN, all internal to the controller.
Report
Name Email  
119.
Suppose that you have just powered up a new controller. If you connect to the controller’s console port, in which one of the following modes will you find the controller?
  • A.
    Initial setup mode
  • B.
    ROMMON mode
  • C.
    Discovery mode
  • D.
    Promiscuous mode
  • Answer & Explanation
  • Report
Answer : [A]
Explanation :
The controller will begin its initial setup to build a bootstrap configuration.
Report
Name Email  
120.
Which of the following methods can you use to perform the initial setup of a wireless LAN controller? (Choose all that apply.)
  • A.
    CLI
  • B.
    TFTP
  • C.
    FTP
  • D.
    Web browser
  • Answer & Explanation
  • Report
Answer : [A and D]
Explanation :
You can either connect to the controller console port or use a web browser to run through the initial setup procedure. The console will use CLI only, while the service port is used for a web interface. A Cisco 2504 Wireless Controller does not have a service port, so a web browser is used from an Ethernet port instead.
Report
Name Email