Home
111.
When a new Cisco Meraki AP is first powered on, it automatically connects with which one of the following?
  • A.
    A Cisco wireless LAN controller
  • B.
    A TFTP server located at 10.0.0.1
  • C.
    The Cisco Meraki cloud network
  • D.
    Nothing; as an autonomous AP, it waits for you to configure its IP address
  • Answer & Explanation
  • Report
Answer : [C]
Explanation :
The AP will connect with the Cisco Meraki cloud network to register itself. At that point, you must browse to the cloud network and claim the AP so that it can be associated with your Meraki Dashboard and account.
Report
Name Email  
112.
A wireless controller port is used for which one of the following purposes?
  • A.
    Construct CAPWAP tunnel packets
  • B.
    Provide a physical connection to a switch port
  • C.
    Create a logical connection to a WLAN
  • D.
    Provide a physical connection to an AP
  • Answer & Explanation
  • Report
Answer : [B]
Explanation :
Controller ports are physical connections to the switched network infrastructure.
Report
Name Email  
113.
Which one of the following is used for remote out-of-band management of a controller and the initial controller setup?
  • A.
    Distribution system port
  • B.
    Virtual interface
  • C.
    Service port
  • D.
    AP-manager interface
  • Answer & Explanation
  • Report
Answer : [C]
Explanation :
The service port is used for out-of-band management.
Report
Name Email  
114.
A distribution system port is usually configured in which one of the following modes?
  • A.
    802.1Q trunk
  • B.
    Access mode
  • C.
    LACP trunk negotiation
  • D.
    Recovery mode
  • Answer & Explanation
  • Report
Answer : [A]
Explanation :
The distribution system ports are usually configured as unconditional 802.1Q trunks.
Report
Name Email  
115.
Which one of the following correctly describes the single logical link formed by bundling all of a controller’s distribution system ports together?
  • A.
    PHY
  • B.
    DSP
  • C.
    LAG
  • D.
    GEC
  • Answer & Explanation
  • Report
Answer : [C]
Explanation :
Controllers use a link aggregation group (LAG) to bundle the ports together.
Report
Name Email