- Home
- Networking
- CCNA Wireless
106.
In its default configuration, which of the following is true of an autonomous AP?
(Choose all that apply.)
- A.Both radios are enabled.
- B.Both radios are disabled.
- C.No SSIDs are configured.
- D.One SSID (“Cisco”) is configured.
- Answer & Explanation
- Report
Answer : [B and C]
Explanation :
Explanation :
| The radios are disabled and no SSIDs are configured. This prevents the AP from becoming active until you have properly configured it. |
107.
Which of the following are correct statements about autonomous AP configuration?
(Choose all that apply.)
- A.Each AP radio must offer an identical set of SSIDs.
- B.Each AP radio can offer a unique set of SSIDs.
- C.Each AP must be configured with the IP address of its controller.
- D.An IP address must be configured on the Ethernet0 interface.
- E.An IP address must be configured on the BVI1 interface.
- Answer & Explanation
- Report
Answer : [B and E]
Explanation :
Explanation :
| Each AP radio can host its own unique set of SSIDs. Also, the AP must assign an IP address to its BVI1 interface for management traffic. |
108.
To convert an autonomous AP into a lightweight AP, which of the following is needed? (Choose all that apply.)
- A.Enter the convert lightweight command in the AP CLI
- B.A TFTP or FTP server
- C.An appropriate lightweight code image
- D.An appropriate autonomous upgrade image
- Answer & Explanation
- Report
Answer : [B and C]
Explanation :
Explanation :
| A TFTP or FTP server is necessary, along with an appropriate lightweight code image. An autonomous code image is not needed because the AP is already running one. |
109.
To upgrade an autonomous AP to lightweight mode, which one of the following initial command keywords should be used from the CLI?
- A.upgrade download-sw
- B.copy flash: tftp:
- C.archive download-sw
- D.download upgrade-sw
- Answer & Explanation
- Report
Answer : [C]
Explanation :
Explanation :
| You should use the archive download-sw command, which also specifies the TFTP server address and filename. |
110.
Which one of the following methods can you use to manage a Cisco Meraki AP?
- A.Console port
- B.CLI via Telnet
- C.Web browser opened to the AP’s IP address
- D.Web browser opened to the Cisco Meraki cloud
- Answer & Explanation
- Report
Answer : [D]
Explanation :
Explanation :
| Cisco Meraki APs are cloud-based, so you must do all management and configuration through the cloud network management interface. |
|
|
||||||||||||||||||||||||||||
