- Home
- Networking
- CCNP Tshoot 300-135
96.
What protocol is used with IPv6 to determine the MAC address of a device in the
same local-area network?
- A.Address Resolution Protocol
- B.Inverse Address Resolution Protocol
- C.Neighbor Discovery Protocol
- D.Neighbor Solicitation
- Answer & Explanation
- Report
Answer : [C]
Explanation :
Explanation :
97.
What type of message is used to determine the MAC address of a known IPv6
address?
- A.Router Solicitation
- B.Router Advertisement
- C.Neighbor Solicitation
- D.Neighbor Advertisement
- Answer & Explanation
- Report
Answer : [C]
Explanation :
Explanation :
98.
Which of the following are true when using EUI-64? (Choose two answers.)
- A.The interface MAC address is used unmodified
- B.The interface MAC address is used with FFFE added to the middle.
- C.The seventh bit from the left in the MAC address is flipped.
- D.The seventh bit from the right in the MAC address is flipped.
- Answer & Explanation
- Report
Answer : [B and C]
Explanation :
Explanation :
99.
What command is used on a Cisco IOS router to enable SLAAC on an interface?
- A.ipv6 address autoconfig
- B.ipv6 address dhcp
- C.ipv6 address prefix eui-64
- D.ipv6 nd ra suppress
- Answer & Explanation
- Report
Answer : [A]
Explanation :
Explanation :
100.
What are requirements for stateless autoconfiguration to function? (Choose three
answers.)
- A.The prefix must be a /64.
- B.The router must be sending and not suppressing RA messages
- C.The router must be enabled for IPv6 unicast routing.
- D.The router must be sending RS messages
- Answer & Explanation
- Report
Answer : [A,B and C]
Explanation :
Explanation :
|
|
||||||||||||||||||||||||||||
