- Home
- Networking
- CCENT/CCNA ICND1 100-105
71.
The output of the show interfaces status command on a 2960 switch shows interface Fa0/1 in a “disabled” state. Which of the following is true about interface Fa0/1? (Choose three answers.)
- A.The interface is configured with the shutdown command.
- B.The show interfaces fa0/1 command will list the interface with two status codes of administratively down and line protocol down.
- C.The show interfaces fa0/1 command will list the interface with two status codes of up and down.
- D.The interface cannot currently be used to forward frames.
- E.The interface can currently be used to forward frames.
- Answer & Explanation
- Report
Answer : [A, B, d]
Explanation :
Explanation :
72.
Switch SW1 uses its Gigabit 0/1 interface to connect to switch SW2’s Gigabit 0/2 interface. SW2’s Gi0/2 interface is configured with the speed 1000 and duplex full commands. SW1 uses all defaults for interface configuration commands on its Gi0/1 interface. Which of the following are true about the link after it comes up? (Choose two answers.)
- A.The link works at 1000 Mbps (1 Gbps).
- B.SW1 attempts to run at 10 Mbps because SW2 has effectively disabled IEEE standard autonegotiation.
- C.The link runs at 1 Gbps, but SW1 uses half-duplex and SW2 uses full duplex.
- D.Both switches use full duplex.
- Answer & Explanation
- Report
Answer : [A and D]
Explanation :
Explanation :
73.
In the following line taken from a show interfaces fa0/1 command, which of the following are true about the interface? (Choose two answers.)
Full-duplex, 100Mbps, media type is 10/100BaseTX
Full-duplex, 100Mbps, media type is 10/100BaseTX
- A.The speed was definitely configured with the speed 100 interface subcommand.
- B.The speed might have been configured with the speed 100 interface subcommand.
- C.The duplex was definitely configured with the duplex full interface subcommand.
- D.The duplex might have been configured with the duplex full interface subcommand.
- Answer & Explanation
- Report
Answer : [B and D]
Explanation :
Explanation :
74.
Which of the following commands list the MAC address table entries for MAC addresses configured by port security? (Choose two answers.)
- A.show mac address-table dynamic
- B.show mac address-table
- C.show mac address-table static
- D.show mac address-table port-security
- Answer & Explanation
- Report
Answer : [B, C]
Explanation :
Explanation :
75.
On a Cisco Catalyst switch, you issue a show mac address-table command. Which of the following answers list information you would likely see in most lines of output? (Choose two answers.)
- A.A MAC address
- B.An IP address
- C.A VLAN ID
- D.Type (broadcast, multicast, or unicast)
- Answer & Explanation
- Report
Answer : [A, C]
Explanation :
Explanation :
|
|
||||||||||||||||||||||||||||
