- Home
- Networking
- CCENT/CCNA ICND1 100-105
51.
Which of the following line subcommands tells a switch to wait until a show command’s output has completed before displaying log messages on the screen?
- A.logging synchronous
- B.no ip domain-lookup
- C.exec-timeout 0 0
- D.history size 15
- Answer & Explanation
- Report
Answer : [A]
Explanation :
Explanation :
52.
Which of the following describes a way to disable IEEE standard autonegotiation on a 10/100 port on a Cisco switch?
- A.Configure the negotiate disable interface subcommand
- B.Configure the no negotiate interface subcommand
- C.Configure the speed 100 interface subcommand
- D.Configure the duplex half interface subcommand
- E.Configure the duplex full interface subcommand
- F.Configure the speed 100 and duplex full interface subcommands
- Answer & Explanation
- Report
Answer : [F]
Explanation :
Explanation :
53.
In which of the following modes of the CLI could you configure the duplex setting for interface Fast Ethernet 0/5?
- A.User mode
- B.Enable mode
- C.Global configuration mode
- D.VLAN mode
- E.Interface configuration mode
- Answer & Explanation
- Report
Answer : [E]
Explanation :
Explanation :
54.
A Cisco Catalyst switch connects with its Gigabit0/1 port to an end user’s PC. The end user, thinking the user is helping, manually sets the PC’s OS to use a speed of 1000 Mbps and to use full duplex, and disables the use of autonegotiation. The switch’s G0/1 port has default settings for speed and duplex. What speed and duplex settings will the switch decide to use? (Choose two answers.)
- A.Full duplex
- B.Half duplex
- C.10 Mbps
- D.1000 Mbps
- Answer & Explanation
- Report
Answer : [A, D]
Explanation :
Explanation :
55.
Which of the following is required when configuring port security with sticky learning?
- A.Setting the maximum number of allowed MAC addresses on the interface with the switchport port-security maximum interface subcommand.
- B.Enabling port security with the switchport port-security interface subcommand.
- C.Defining the specific allowed MAC addresses using the switchport port-security mac-address interface subcommand.
- D.All the other answers list required commands.
- Answer & Explanation
- Report
Answer : [B]
Explanation :
Explanation :
|
|
||||||||||||||||||||||||||||
